Vehicle centre console mount for Bong Design
A centre console mount for Bong Design's car audio controller, 3D printed in ABS, checked on the device, then painted and clear coated.
- Client
- Bong Design
- What it holds
- A car audio controller with a screen and a control knob
- Made in
- ABS, painted and clear coated
- Started from
- Bong Design's own 3D model
What we brought
What we can do
Fit checked on your device
We seated the controller in the raw print and flagged the tight spots before any paint went on.
How we look after you
A colour agreed with you
We sprayed a test sample and agreed a more vibrant colour with Bong Design.
What you get
A finish given time to cure
We held collection until the clear coat had cured, so the finish would not mark.
Gallery
The whole project at a glance. Drag or swipe to browse; tap a picture to enlarge it.
1 / 4
-
The finished piece
-
Printing and the fit checkThe gap along the side, marked.
-
Paint and clear coatThe colour, tried on a test sample.
-
The first coat in the spray booth.
The build
How we built it
4 steps, from the brief to the finished piece. Pick a step to jump to it.
The brief
Step 1 of 4 · 29/06/2026
- The part
- A mount that holds the controller in a vehicle's centre console
- Material
- ABS
- Finish
- Paint and a clear coat
At Additive Inn, our 3D printing studio in Singapore, we print and finish parts from our clients' own files. Bong Design needed a centre console mount for a car audio controller, 3D printed in ABS, then painted and clear coated.
Printing and the fit check
Step 2 of 4 · 01/07/2026
We 3D printed the mount in ABS from Bong Design's model and seated the controller in it. It pushed home but sat tight at two entry points, with a gap along one side, so we told Bong Design before painting.
Paint and clear coat
Step 3 of 4 · 01/07/2026
We sprayed a colour sample and agreed a more vibrant colour than first requested. The mount took a first coat in the spray booth, then the colour, then a protective clear coat left to cure.
The final build
Step 4 of 4 · 03/07/2026
Bong Design collected the mount on 03/07/2026, once the clear coat had cured. A few days later they told us it was all good.
More production runs
See all production runs →-
Osteria Mozza (OUE) Laser-engraved serving boards for Osteria Mozza Osteria Mozza's logo, laser-engraved on 90 wooden serving boards for OUE's restaurant at ION Orchard, after eleven test settings on a spare board. -
S-Cool Services Reverse-engineered vent parts for S-Cool Services Four vent parts rebuilt in CAD from S-Cool Services' own samples, one redesigned with straight slats, then 3D printed in PLA in white and black. -
3D printed chess sets for McLaren Matching chess sets in McLaren grey and orange, made as one batch: each set's pieces sit in a 3D printed tray lined with laser-cut foam.