Additive Inn
Get instant quote

Painted figurine of a boxer on a magnetic base

A 150 mm figure in a boxer's pose, printed in resin from the client's own files, airbrushed to their reference and set on a black base held by magnets.

Made from
The client's own print-ready 3D files and a colour reference
Size
150 mm tall, on a hexagon base about 100 by 87 mm
Finish
Airbrushed by hand over grey primer
Height of the figure
150 mm
Magnets holding it to the base
25 x 6 x 3 mm

What we brought

  1. What we can do

    Printed from the client's files

    The client sent print-ready files for the figure and its base, so the work started at the printer, with no modelling stage.

  2. How we look after you

    Fine detail in resin

    SLA in white ABS-like resin keeps the face, the hair and the clenched fingers sharp before any paint goes on.

  3. What you get

    Lifts off its base by hand

    Magnets set into the black PLA base hold the figure firm, and it lifts off without tools.

The build

How we built it

4 steps, from the brief to the finished piece. Pick a step to jump to it.

The brief

Step 1 of 4 · 09/07/2026

Source
The client's print-ready files and a colour reference
Figure
150 mm tall, SLA resin
Base
Black PLA with magnets
Quantity
One figure

At Additive Inn, our 3D printing studio in Singapore, we made a 150 mm painted figure of a man in a boxer's pose: grey hair, a black vest and shorts, fists up. The client supplied print-ready files for the figure and its base, and a colour reference for the paint.

RenderThe client's colour reference.

Production

Step 2 of 4 · 11/07/2026

The figure was SLA printed in white ABS-like resin, which holds the fine detail of the face, the hair and the fingers. The base was printed in black PLA, with recessed slots for 25 x 6 x 3 mm magnets. The figure was then primed grey, so every detail showed clean before paint.

Off the printer, in white resin.
Primed grey, ready for paint.

Painting by hand

Step 3 of 4 · 17/07/2026

The figure was airbrushed in our spray booth to the client's reference: skin tones first, then the grey hair, the black vest, shorts, shoes and watch, with the shoe soles picked out in grey. The client approved the finished paint before it was collected.

First skin tones in the spray booth.

The final build

Step 4 of 4 · 04/08/2026

The finished figure stands on its black hexagon base, held by the magnets, and lifts off by hand. It was collected from our studio.

The face and fists up close.

Likeness

From a front corner.
From the other side.
Face on.

More figurines & props

See all figurines & props →
Chat with us