Captain America figurine for Colorverse
A hand-painted Captain America figurine, printed in resin and posed mid-throw on a diorama base of broken concrete and rebar.
- Client
- Colorverse
- Service
- Custom 3D Figurines
- What it is
- A painted Captain America figurine on its own diorama base
- What it is made of
- Resin, primed and painted by hand
- Finish
- Comic-book shading, a metallic shield and a weathered base
What we brought
What we can do
Fine detail that survives the paint
Resin holds the scale texture of the suit and the star on the chest, crisp under every coat.
How we look after you
A base that tells the story
Broken concrete, rebar and a hazard barrier set the scene, weathered with dust and rust.
What you get
Finished and ready for the shelf
Primed and painted by hand in comic-book colour, the piece arrives finished and ready to display.
Gallery
The whole project at a glance. Drag or swipe to browse; tap a picture to enlarge it.
1 / 27
-
The finished piece
-
The whole piece on its base.
-
Side on, the shield thrown out.
-
From low down, over the rubble.
-
From slightly below.
-
The whole piece, further back.
-
Portrait, the whole piece.
-
From the shield side.
-
From the other side.
-
Mid-throw.
-
The upper body, angled.
-
Against white.
-
The shield in front.
-
The face, fist and scaled suit.
-
Fist up, mid-throw.
-
The metallic red and silver shield.
-
ProductionBroken concrete, printed with every edge.
-
Rubble, girder and hazard barrier.
-
Priming, painting and assemblyThe back, shaded panel by panel.
-
Boots, girder and rubble, painted together.
-
The rubble base up close.
-
Along the base.
-
The scale texture on the suit.
-
The front paintwork.
-
The back paintwork.
-
The shield up close.
-
In on the shield.
The build
How we built it
4 steps, from the brief to the finished piece. Pick a step to jump to it.
The brief
Step 1 of 4
- Use
- Display collectible
- Pose
- Shield swept out, fist cocked, one foot on the rubble
- Scene
- Broken concrete, rebar and a hazard barrier
At Additive Inn, our 3D printing studio in Singapore, we made a hand-painted Captain America figurine for Colorverse. The need was a collectible that looks lifted from a comic panel: a throwing pose, caught mid-fight, standing in its own scene.
Production
Step 2 of 4
We prepared the figure and a matching rubble base, and both were printed in resin. Resin holds what this piece depends on: the scale texture of the suit, the folds of the gloves and boots, and the sharp broken edges of the concrete.
Priming, painting and assembly
Step 3 of 4
The parts were cleaned, primed and assembled, then painted by hand. Every panel of the suit was shaded and highlighted in comic-book colour, the shield finished in metallic red and silver, and the rubble weathered with dust and rust.
The final build
Step 4 of 4
The finished figurine stands mid-throw on its rubble base, shield out and fist raised, painted from helmet to boots and ready for the shelf.
Likeness
Close-ups of the face, the suit and the shield.
More figurines & props
See all figurines & props →-
Private client Hand-painted figure of an artist's cartoon character An artist's own cartoon character as a 200 mm figure: modelled from her drawings and turntable video, printed in resin and airbrushed in flat colour. -
Hand-painted coin-sized princess miniature A resin princess miniature, shown beside a coin for scale, painted by hand from silk-look robes to a glowing ember base.