Resin 3D printed wire holder
A small wire holder delivered in orange resin, with fine parallel grooves that keep wires in line, a round peg and a mounting hole.
- What it is
- A small part that keeps wires in parallel grooves
- Underneath
- A round peg
- Delivered in
- Orange resin, supports removed
What we brought
What we can do
Fine grooves, held crisp
Narrow parallel grooves keep each wire in its own lane, and resin holds those small ridges crisp.
How we look after you
Printed tilted, on supports
It was printed at an angle on fine support pins, which were cut away to leave clean faces.
What you get
Small part, full detail
The grooves, the round peg and the corner hole all come from one print, with nothing to assemble.
Gallery
The whole project at a glance. Drag or swipe to browse; tap a picture to enlarge it.
1 / 8
-
The finished piece
-
From above, grooves and hole.
-
From the front, peg forward.
-
Turned over, peg up.
-
ProductionTilted on its supports.
-
The peg side, on its pins.
-
The grooved bridge, still supported.
-
Build and assemblySupports off, side profile.
The build
How we built it
4 steps, from the brief to the finished piece. Pick a step to jump to it.
The brief
Step 1 of 4
- Grooves
- A row of narrow parallel channels
- Underneath
- A round peg
- Fixing
- A small hole at one corner
At Additive Inn, our 3D printing studio in Singapore, we delivered a small wire holder in orange resin. The need: fine parallel grooves to keep wires in line, a round peg underneath and a mounting hole.
Production
Step 2 of 4
The holder was 3D printed in orange resin, tilted at an angle on a raft of fine support pins.
Build and assembly
Step 3 of 4
The supports were cut away, leaving the grooves, the round peg and the corner hole clean, with nothing else to fit.
The final build
Step 4 of 4
The finished holder, photographed from every side: the grooved face, the bridge across it, the peg below and the mounting hole.
More product development
See all product development →-
Private client Custom 3D printed golf putter head A putter head designed from scratch: a 3-degree loft, two pockets that set its mass, and the loft and mass marked on the back. -
18 DA Bn, Singapore Armed Forces Custom stainless steel housing for an SAF missile manpack A stainless steel carry sleeve for an RBS 70 missile, drawn from the SAF team's own sketch, rolled from sheet and closed with toggle latches. -
Collapsible shelter prototype A working scale model of a lamp post shelter for pedestrian crossings, 3D printed with hinged panels that fold away and open by hand.