320 laser-cut pop-out wooden kits
320 wooden pop-out kits for goodie bags, laser cut from the client's own sheets in three days, each piece held by tabs and the logo scored.
- Service
- Laser Engraving & Cutting
- Also used
- Laser cutting & stickers
- What it is
- A wooden kit whose pieces pop out of the sheet
- How many
- 320 sets
- Turnaround
- Three days from the material arriving
- Sets cut and packed
- 320
- Days, material in to collection
- 3
What we brought
What we can do
Pieces that stay put until popped
Every part is held in the sheet by small tabs, so a kit stays in one piece in the bag and pops apart by hand.
How we look after you
Natural wood, honest expectations
Plywood varies from board to board in flatness and thickness, and no cutting can take that out, so results can vary between boards. If you need it, we can cut a sample on your board and test it first.
What you get
Scored, not shaded
We checked the first batch with the client and switched the logo from a filled engrave to fine scoring, so every line of the letters reads.
Gallery
The whole project at a glance. Drag or swipe to browse; tap a picture to enlarge it.
1 / 8
-
The finished piece
-
One kit, close up.
-
Checking the fileDrawingThe client's file, with the tab points marked.
-
First batch, the logo as a shaded engrave.
-
The logo scored in fine lines instead.
-
Cutting the runSheets from the run.
-
Laid out for checking.
-
Checking and packingStacked as sets, ready for collection.
The build
How we built it
5 steps, from the brief to the finished piece. Pick a step to jump to it.
The brief
Step 1 of 5
- Quantity
- 320 sets
- Material
- Thin plywood, supplied by the client
- Our scope
- Laser cutting, checking and packing
At Additive Inn, our 3D printing studio in Singapore, we laser cut 320 wooden pop-out kits to go into an event's goodie bags. The client supplied the cutting file and the plywood sheets; we cut, checked and packed every set in time for their packing day.
Checking the file
Step 2 of 5
Before cutting we went through the file with the client: every part keeps small tabs so it stays in the sheet until it is popped out. On the first batch the logo came out as a shaded engrave, so we switched it to fine scoring, which keeps the inner lines of the letters clear.
Cutting the run
Step 3 of 5
The sheets were cut on the laser over three days. Natural wood varies from board to board in flatness and thickness. The laser cuts each board as it lies, so the result can vary a little from board to board.
Checking and packing
Step 4 of 5
The sheets were checked and packed as sets, and all 320 sets were collected together.
The final build
Step 5 of 5
Each kit is one sheet of thin plywood with its parts held in by tabs and the logo scored in one corner, ready to pop apart and build.
More production runs
See all production runs →-
Osteria Mozza (OUE) Laser-engraved serving boards for Osteria Mozza Osteria Mozza's logo, laser-engraved on 90 wooden serving boards for OUE's restaurant at ION Orchard, after eleven test settings on a spare board. -
S-Cool Services Reverse-engineered vent parts for S-Cool Services Four vent parts rebuilt in CAD from S-Cool Services' own samples, one redesigned with straight slats, then 3D printed in PLA in white and black.