GSAB Emblem Plaque and Keychains, 3D Printed

3D printed emblem plaque and keychains for GSAB

GSAB's wolf emblem, 3D printed as a layered plaque in black, red and white, with matching keychains.

Client

GSAB

Service

Custom Signage

What they got

Their emblem as a plaque, with keychains to match

What it is made of

3D printed plastic in black, red and white

How it reads

Raised layers, down to the small base name

What we brought

What we can do

Your emblem in layers you can feel

Each colour stands at its own height, from the black disc up to the raised red lettering.

How we look after you

Fine detail that stays readable

The wolf's fur edges and the small base name below GSAB come out crisp and readable.

What you get

A plaque and keychains that match

The keychains carry the same wolf and lettering, so the whole set reads as one.

The brief

Step 1 of 4

Emblem: A white wolf on a red circle, ringed by the motto Safety, Accountability, Security
Colours: Black, red and white
Pieces: A round plaque, and round keychains to match

At Additive Inn, our 3D printing studio in Singapore, we made an emblem plaque and matching keychains for GSAB, the General Support Ammunition Base. They needed their wolf emblem raised in its own three colours.

Production

Step 2 of 4

We 3D printed the plaque in black, red and white, each colour at its own height: the black disc, the red circle, the white wolf and band, then the raised red lettering.

Close-up of the raised red GSAB letters on the white band, the fine print lines visible on top and the base name below — The raised red lettering up close.

The plaque from a low angle: the white wolf standing above the red circle, which stands above the black disc — Each colour at its own height.

Build and assembly

Step 3 of 4

The keychains carry the same wolf and GSAB lettering in red on white discs, each fitted with a split ring and a short chain.

Two round white keychains with the red wolf emblem and GSAB lettering, on split rings and short chains, below the plaque — The keychains, on split rings.

The final build

Step 4 of 4

GSAB got its wolf emblem as a layered plaque in three colours, with keychains to match.

The finished plaque and keychains on a grey table, seen from above — The finished set from above.

3D printed emblem plaque and keychains for GSAB