Additive Inn
Get instant quote

Sliding wall mount with a 90° bracket

A sliding wall mount for a private client: a 90° bracket that hooks onto a slider, extended from a 100 mm design to 200 mm and 3D printed in white PETG.

Client
A private client
What it is
A sliding wall mount, a 90° bracket on a slider
What we did
3D design over three revisions, then the prints
What the client got
Four 3D printed parts in white PETG
Start a prototype (opens WhatsApp) Send a brief
Slider in the updated design, up from 100 mm
200 mm
Wide bracket, up from 23 mm
40 mm
Design revisions
3
Parts printed in white PETG
4

What we brought

  1. What we can do

    Twice the length

    The updated slider is 200 mm long, double the old 100 mm design, and the bracket grew from 23 to 40 mm wide.

  2. How we look after you

    The slots, revised twice

    The bracket's slots went from two short slots near one edge, to long slots across it, to shorter slots in the middle.

  3. What you get

    Printed in our studio

    Once the design was settled, we printed four parts of it in white PETG.

The build

How we built it

5 steps, from the brief to the finished piece. Pick a step to jump to it.

The brief

Step 1 of 5

Old design
100 mm slider, 23 mm bracket
Updated design
200 mm slider, 40 mm bracket
Our scope
3D design over three revisions, four prints in white PETG

At Additive Inn, our 3D printing studio in Singapore, we designed and 3D printed a sliding wall mount for a private client. A 90° bracket hooks onto a slider and slides along it. The job was to extend the old 100 mm design.

Three revisions

Step 2 of 5

Every revision kept the same layout: the 90° bracket at the corner, hooked over the top and bottom edges of the slider. Each slide set the old design beside the updated one. What changed between revisions was the slots in the bracket.

  1. Revision 0

    A 200 mm slider and a 40 mm bracket with two short slots near one edge.

    Render

  2. Revision 1

    The bracket's two slots run almost its full width.

    Render

  3. Revision 2

    Shorter slots, set in the middle of the bracket.

    Render

The prints

Step 3 of 5

We 3D printed four parts of the extended design in white PETG in our studio.

How it goes together

Step 4 of 5

The 90° bracket hooks over the top and bottom edges of the slider, so it can slide along its length.

The final build

Step 5 of 5

The client received four white PETG parts of the extended sliding wall mount.

RenderThe bracket hooked onto the slider.

More product development

See all product development →
Chat with us