Custom angle trim strip
A one-off black angle trim strip for a private client, 3D printed in one piece to a right-angled profile with a lip along its edge.
- Service
- Industrial 3D Printing
- Made in
- Black plastic, printed layer by layer on our FDM printers
- Inside the channel
- A raised step running along the base
- Finish
- As printed, matt black, with no paint or coating
What we brought
What we can do
The exact profile, not the nearest stock size
We printed the shape asked for: a right angle, a lip along the upright and a step inside.
How we look after you
One piece along its whole length
The strip came off the printer as one continuous length, with no joins or glued sections along the run.
What you get
One part is a real order
This job was a single strip. We make one-offs as readily as batches, with no minimum order.
Gallery
The whole project at a glance. Drag or swipe to browse; tap a picture to enlarge it.
1 / 5
-
The finished piece
-
The whole strip, end to end.
-
From above, straight along its length.
-
The open side of the channel.
-
The profile, up closeThe end of the strip, showing its profile.
The build
How we built it
4 steps, from the brief to the finished piece. Pick a step to jump to it.
The brief
Step 1 of 4
- Shape
- A right angle with a lip along the upright
- Colour
- Black
- Quantity
- One strip
At Additive Inn, our 3D printing studio in Singapore, we made a custom angle trim strip for a private client. They needed one length of black right-angled channel, with a lip along the top of the upright, made to their own profile.
Production
Step 2 of 4
We printed the strip in black plastic on our own FDM printers, as one continuous piece, base down on the bed, so the right angle, the lip and the step inside the channel all came out in a single print.
The profile, up close
Step 3 of 4
Here is the end of the strip, showing the right angle, the lip over the top of the upright and the step inside the channel.
The final build
Step 4 of 4
The client received one straight black strip with a clean right angle and an even lip along its full length, ready to fit where they needed it.
More production runs
See all production runs →-
Garang Garage 3D printed body panels for Garang Garage A full set of replacement body panels for a Yamaha dual-sport, 3D printed in ASA from Garang Garage's own model, primed and painted matt grey. -
Resin forearm and hand bone model A forearm and hand bone model for a medical client, printed in resin from scan data, in a tinted translucent set and a clear set. -
Custom 3D printed brackets and fittings Small made-to-order parts from separate jobs: a wall bracket and clip, a flanged pipe elbow, a bent bracket, a support arm and a tray.