Spider trophy for Peso Pluma

Clear resin keepsakes for VIP guests at Peso Pluma's Singapore concert, each holding a 3D-printed purple tarantula, his spirit animal.

Client: Peso Pluma
Service: Customised Corporate Gifts
What they got: A keepsake in a holographic gift box
Resin blocks cast in one batch: 20

Commission a trophy Send a brief

What we brought

What we can do
A printed spider, sealed in clear resin
We printed and coloured the tarantula, then cast it in clear epoxy so it seems to float inside the block.
How we look after you
Every block cast to match
We poured all twenty moulds in one batch, torching each pour to lift the bubbles before it set.
What you get
Ready to hand over
Each block carries Peso Pluma's Doble P mark, with holographic gift boxes lined in black.

Gallery

The whole project at a glance. Drag or swipe to browse; tap a picture to enlarge it.

1 / 11

The finished piece
All twenty blocks, ready to hand over.
The tarantula standing inside the block.
Three blocks around a holographic box.
The tarantula's back and banded legs.
The Doble P mark above the spider.
Lit from behind, the resin glows.
ProductionTwenty moulds laid out for the pour.
Clear epoxy poured into the moulds.
A torch lifts bubbles from the resin.
Build and assemblyA block in its holographic gift box.

The build

How we built it

4 steps, from the brief to the finished piece. Pick a step to jump to it.

The brief

Step 1 of 4

Use: Gift for VIP guests at the concert

At Additive Inn, our 3D printing studio in Singapore, we made clear resin keepsakes for Peso Pluma's Singapore concert. The spider is his spirit animal, so each VIP guest would take home a tarantula sealed in a block, carrying his mark.

Production

Step 2 of 4

We 3D printed and coloured each tarantula, then poured clear epoxy into twenty moulds in one batch, setting a spider into each and passing a torch over every pour to lift the bubbles.

Twenty clear moulds laid out in rows on a black sheet, ready for the resin — Twenty moulds laid out for the pour.

Clear epoxy poured into the moulds.

A torch lifts bubbles from the resin.

Build and assembly

Step 3 of 4

Once the resin had set, each block came out of its mould and went into a holographic gift box lined in black.

A resin block sitting in an open holographic gift box with a black lining, the spider seen from below with the Doble P mark above — A block in its holographic gift box.

The final build

Step 4 of 4

All twenty blocks were finished, each holding a purple tarantula that seems to float in clear resin, ready for Peso Pluma's VIP guests.

All twenty finished resin blocks laid out in four rows of five, each with a purple and pink tarantula inside — All twenty blocks, ready to hand over.

Finish close-ups

The banded legs, the Doble P mark above the spider and the clear resin lit from behind.

Close-up of a resin block from above: the tarantula's back with a dark red marking and purple and pink banded legs — The tarantula's back and banded legs.

A resin block seen from above, the spider spread in the middle and the Doble P mark above it — The Doble P mark above the spider.

A resin block standing on a holographic base, lit from behind so the clear resin glows around the purple spider — Lit from behind, the resin glows.

More trophies and gifts

See all trophies & gifts →

Spider trophy for Peso Pluma

What we brought

A printed spider, sealed in clear resin

Every block cast to match

Ready to hand over

Gallery