Additive Inn
Get instant quote

Custom moon jewellery box for Confetti by Mui

A moon that opens: a jewellery box for Confetti by Mui, primed and hand-painted, closing on magnets around a foam insert with their logo.

Client
Confetti by Mui
Also used
Custom boxes
Made for
A jewellery store on Orchard Road, Singapore
What it is made of
Resin, sanded, primed and painted in greys
Plan a custom box (opens WhatsApp) Send a brief
Across the closed moon
About 10 cm
Width of the foam insert in each half
92 mm
From the approved quote to the finished box
6 days

What we brought

  1. What we can do

    A box shaped like the moon

    Not a stock box: a moon that splits at its middle, with the jewellery bedded inside.

  2. How we look after you

    Designed to hold the piece in place

    We drew a layered foam insert with pockets cut for the piece, glued into each half.

  3. What you get

    Finished by hand, with your brand inside

    Sanded, primed and painted in greys to read as the moon, with Confetti by Mui's logo on the foam.

The build

How we built it

5 steps, from the brief to the finished piece. Pick a step to jump to it.

The brief

Step 1 of 5

Size
About 10 to 11 cm across
Closure
Magnets set into the two halves
Finish
Primed and painted in greys, like the moon
Inside
A die-cut foam insert to hold the piece

At Additive Inn, our 3D printing studio in Singapore, we designed and finished a jewellery box for Confetti by Mui. The quote set out a moon-shaped box that closes on magnets, with a custom foam insert.

Design and prototyping

Step 2 of 5

We modelled the moon as two halves meeting at the middle, with magnet posts round the rim, and drew the foam insert to match: 92 mm across, 20 mm deep, layered, notched round the posts and cut with pockets for the piece.

DrawingThe foam insert, drawn to fit each half.

Production

Step 3 of 5

The two halves were printed in resin with the crater relief built into the surface, then washed and cured. Each half carries a ring of raised posts round its rim to take the magnets.

Washing the raw resin print.
The two halves and their magnet posts.
Crater relief on the unpainted print.

Build and assembly

Step 4 of 5

We sanded, filled and primed both halves, then painted them in greys so the craters read like the moon. The foam was cut in layers, glued together and fitted into each half around the magnet posts.

Gluing the layered foam inserts.
Fitting the logo layer into a half.

The final build

Step 5 of 5

Confetti by Mui got a closed grey moon that pulls apart on its magnets into two foam-lined halves, with their logo on the foam and the piece held in its pocket.

Both halves open, foam fitted.

More product development

See all product development →
Chat with us